Gallery Activities

The following list shows just some of the approved methodologies under the Clean Development Mechanism (CDM) of the UNFCCC that can be offered to be developed in Ghana or are currently under development by Carbon Ghana Limited:

Upstream Downstream Oil & Gas CDM Projects

 

- Consolidated baseline methodology for GHG emission reductions from waste energy recovery projects

- Consolidated baseline methodology for fuel switching from coal and/or petroleum fuels to natural gas in existing power plants for electricity generation

- Consolidated methodology for industrial fuel switching from coal or petroleum fuels to natural gas

- Methodology for gas based energy generation in an industrial facility

  • Recovery of gas from oil wells that would otherwise be vented or flared and its delivery to specific end-users

  • Flare (or vent) reduction and utilization of gas from oil wells as a feedstock

  • Recovery and utilization of gas from oil wells that would otherwise be flared or vented

New Energy Generation CDM Projects

 

- Consolidated baseline and monitoring methodology for new grid connected fossil fuel fired power plants using a less GHG intensive technology

  • Construction of a new natural gas power plant supplying electricity to the grid or a single consumer

  • Methodology for Grid Connected Electricity Generation Plants using Natural Gas

  • Methodology for Grid Connected Electricity Generation Plants using Natural Gas

Renewable Energy CDM Projects

  • Consolidated methodology for grid-connected electricity generation from renewable sources

  • Increased electricity generation from existing hydropower stations through Decision Support System optimization

  •  

Energy Efficiency & Combined Cycle Power Generation CDM Projects

  • Methodology for conversion from single cycle to combined cycle power generation

  • Energy efficiency improvements of a power plant through retrofitting turbines

  • Methodology for rehabilitation and/or energy efficiency improvement in existing power plants

Electrical Efficiency CDM Projects

  • Methodology for installation of energy efficient transformers in a power distribution grid

  • Distribution of efficient light bulbs to households

  • SF6 Emission Reductions in Electrical Grids

Petrochemical & Refinery CDM Projects

  • Baseline and Monitoring Methodology for the recovery and utilization of waste gas in refinery facilities

  • Methodology for gas based energy generation in an industrial facility

  • Methodology for GHG emission reductions from waste energy recovery projects

Transport CDM Projects

  • Consolidated methodology for fuel switching from petroleum fuels to natural gas (in vehicles)

  • Baseline Methodology for Mass Rapid Transit Projects

  • Baseline Methodology for a Bus Rapid Transit Project

Cement, Aluminium & Fertilizer CDM Projects

 

- Consolidated Methodology for Increasing the Blend in Cement Production

- Emissions reduction through partial substitution of fossil fuels with alternative fuels or less carbon intensive fuels in cement manufacture

- Consolidated baseline and monitoring methodology for project activities using alternative raw materials that do not contain carbonates for clinker production in cement kilns

  • Methodology for greenhouse gas reductions through waste heat recovery and utilization for power generation at cement plants

  • Reduction in GHGs emission from primary aluminium smelters

  • PFC emission reductions from anode effect mitigation at primary aluminium smelting facilities

Landfill & Waste Management CDM Projects

 

- Consolidated baseline and monitoring methodology for landfill gas project activities

  •  

  •  

  •